keyboard_arrow_left
keyboard_arrow_right
clear
keyboard_arrow_left
zoom_in
keyboard_arrow_right
zoom_in
CURVED INNER PANEL 28-31 ROADSTER/30-31 COUPE
Part #
A-161-AB
|
Model Year
28-31
This is the panel just below the rumble lid on the inside. When converting the trunk to a rumble seat, this panel is needed so the rumble lid will have clearance when opening and closing. The top of this panel mounts to the panel below the deck lid, and the bottom sits on top of the rumble platform. U.S.A.
Part #
A-1401
|
Model Year
30-31
For the Coupes and Roadsters with a rear mounted spare tire. This bracket follows the contour of the curved inner panel, and the top bolt on the carrier goes through the hole in the end. Only for cars with deck lids hinged for rumble seats. U.S.A.
Part #
A-159-AB
|
Model Year
28-31
This panel is used in the deck area of Coupes and Roadsters. It was used regardless of whether you were using the back of your car as a trunk or a rumble seat. The reason it was used in trunk applications is that it provided clearance for the rear cross member of the frame. This is the panel that your cushion seat spring would set on. Very good die stamped panels. U.S.A.
Part #
A-160-AB
|
Model Year
28-31
The brackets that support the rain gutter at the rear corner of the rumble compartment. The sides attach to the end of the curved inner panel. U.S.A.