MODEL T - DRIVE SHAFT
Model T Universal Joint
$110.00 / ea.
These are brand new forged units.
Model T Universal Joint Align Tool
$31.50 / ea.
A copy of a tool that was originally manufactured by the Frank Mossberg Company.
Model T U Joint Bolt Kit
$6.50 / set
Bolts, castellated nuts, cotters, and wire.
Model T U Joint Pin
$0.45 / ea.
The special pin to fasten the universal joint onto the drive shaft.
Model T U Joint Housing Plug
This is the plug used in the torque tube to install and remove the universal joint pin.
Model T Grease Cup
The large grease cup used to grease the U joint.
Model T Ball Joint Gasket
$1.25 / ea.
Install between the back of the oil pan and the ball cap.
Model T Universal Joint Shim
$4.95 / ea.
The shim used to tighten play between the universal joint housing and the rear universal ball cap.
Model T Drive Shaft Bushing
$8.50 / ea.
A well made brass bushing for the front of the drive shaft.
Model T Bushing Puller
$22.00 / ea.
A special tool used for removing the T-2581 drive shaft bushing from the torque tube.
Model T Drive Shaft Bushing Driver
$14.00 / ea.
A bushing driver used to install the T-2581 drive shaft bushing in the torque tube, U.
Model T Bushing Facing Tool
$59.95 / ea.
After a new T-2581 drive shaft bushing is installed, the face must be cut to install the universal joint properly.