To order multiple products on this page, enter the quantity for each product you would like to purchase, and then select "add to cart" to checkout.
The cup shaped cover that covers the bendix drive once the starter is installed. Bolts to hogs head. U.S.A.
U.S.A.
A really nice repo of the original spring.
Set of 4 insulators that insulate the brush holders at the brush plate. U.S.A.
A four piece set of the brushes needed for the Model T starter motor. U.S.A.
This supports the counterweight on the gear that slides in and out. U.S.A.
The brass bushing used in the front of the starter motor. U.S.A.
For mounting the starter motor. U.S.A.
Insulates the terminal stud inside the starter case. Fiber. U.S.A.
This screw usually takes a beating getting it out. It is the screw that goes through the generator casting, and holds the heavy steel plates that hold the fields in place. Also used on Model...
If after putting in new brushes the starter still drags. The front and rear bushings may be worn and needed replaced. U.S.A.
Starter brush plate is taken apart and rebuilt with new insulators. These units are sold on exchange only and we MUST have your core on hand before we can send you a rebuilt unit. Core must have...
Available on exchange only. We must have a rebuildable starter before we can ship out a rebuilt unit. Remove starter drive and cover band before sending. This s a complete rebuild. U.S.A.
Complete drive assembly, including the key. Excellent quality.
Both special 5/16" bolts with the two locking washers. U.S.A.
These screws have a special thread. About half way between fine and coarse. U.S.A.
Very well made! T-5021-PS is not included.
