Model T Control Rods

See additional features

Not correct for the early T's to 1921 but will work. U.S.A.

See additional features

USA

A little accessory for the spark & gas rod levers. Just slide over the ends of the rods, and tighten the set screw to hold them in place. Gets the levers away from the steering wheel.

U.S.A

Correct adjustment of the carburetor and timer are achieved by bending the control rods. These handy tools make it easy to bend the rods. 3 piece set. U.S.A.

Early T's used these black round knobs on the ends of the spark and gas rods.

See additional features

Newly manufactured control rods. Made as original ones were except in stainless steel. U.S.A.

See additional features

Cast lever gets pinned to the end of the spark rod that runs down the steering column, and hooks the rod that goes from the steering column to the timer. U.S.A.

Holds spark/gas rods in place on steering shaft. Mounts about half way between firewall and steering bracket. U.S.A.

See additional features

This handy tool slides over the end of your spark/gas rods and compresses the springs. After they are compressed, there is a slot in the tool so you can install the pins. Comes with instructions....

For the spark and gas rod springs. U.S.A.

See additional features

For the gas and spark rods. U.S.A.

See additional features

Pins to the throttle rod for the carb rod to attach to. U.S.A.