To order multiple products on this page, enter the quantity for each product you would like to purchase, and then select "add to cart" to checkout.
No need to change or modify the stock gauges or senders. Just install the electronic voltage reducer on the back of each gauge, and the gauges will continue to run on 6-volts, while the rest...
The braided steel
ground strap. U.S.A.
This special headed bolt was used to attach the ground strap to the cross member of the frame from 1928 t0 March of 1930. U.S.A.
These black plastic inserts go where the wires enter the
base of the headlight to keep the wires separated. The 1928 style is for the early headlights that had the smaller hole. The early ones...
Grommet used on the terminal box. U.S.A.
Mounts on bottom of steering column. The light wire harness slips inside this unit to turn lights off and on.
Clip that holds the main lighting
wire harness on the left frame
This harness gives you everything our regular lighting harness does, plus it has all the wires for directional lights. NOTE: This harness is constructed to accommodate bumper-mounted front signal...
On the later years
Ford used a loom instead of a metal conduit on the A-14406 wire. U.S.A.
This is a modern type coil wire that has the ends soldered in place so you're sure you have a good connection. Also has rubber boot installed. "Genuine Nu-Rex". U.S.A.
A complete set of the conduits that come out of the radiator shell. One for the horn, and two for the headlights. 9/16 size. Ferrules included. U.S.A.
The complete terminal box.
Comes with mounting hardware,
wing nuts, and cover.
This is the lid only for the
The four screws needed to mount
the terminal box to the firewall. U.S.A.
Exact copy of the original with heavy correctly colored wire as well as the correct end clips.
This clip holds the cut-out to terminal
box wire on the firewall. For the early
style with steel conduit. U.S.A.
Used on: 1928-31 Water Inlet. 1928-31 Speedo cable reside firewall. 1930-31 Cut-out wire on firewall. U.S.A.
The short fine threaded bolt and
l/w used to mount the wire clip to
the water inlet. U.S.A.
A pack of 10 wire clips for
holding the wiring onto the
frame rails. Price is for pack of 10. U.S.A.
These double female connectors
were used to connect one harness to another. Accepts the bullet style wire ends. Each set contains 6 connectors. U.S.A.