To order multiple products on this page, enter the quantity for each product you would like to purchase, and then select "add to cart" to checkout.
This is the cable that runs from the battery to the starter switch. Correct braided fabric covered 2/0 cable. U.S.A.
This style of disconnect attaches directly to the terminal on the battery, and cable attaches to the opposite end of the switch. Attaches to the negative post. Simply lift up the battery access...
Use this special cable when using the A-14300-D battery disconnect switch with our A-14300-DMB bracket that mounts the disconnect switch between the starter and the frame. This cable has an eyelet...
Bolt, nut and l/w to bolt the battery ground strap to the cross member. U.S.A.
For the terminal box.
Black fabric wire loom is what older cars used instead of the modern plastic loom that is readily available today. Cut to order, so it is non returnable. The Ford Model A fabric loom is sold...
Authentic cloth covered wire that will look correct on your antique auto. 14 gauge. All wire is cut to your specified length so it is not returnable. The price for classic car wiring is per...
The small wire ends that get crimped onto the wire ends to plug into the A-14487 wire connectors. U.S.A.
This support bolts onto the transmission case. Holds the battery cable so it will not rub against the pedals and short out. U.S.A.
The conduit that the wires go through from the radiator shell to the headlight and horn. Early 28 has the 5/8" hole out the back of the headlight. Ferrules included
Black cloth covered wire with correct soldered ends. U.S.A.
The black lacquer wire that runs from the coil to the distributor. Comes with two brass wire ends. U.S.A.
This piece slips up on the headlight wire conduits and holds the conduits to the headlight sockets. These come with conduit sets. Stainless. U.S.A.
The flat copper ground strap that Henry used. All A's had this originally. U.S.A.
This fabric covered wire was used from Feb. of 1930 through the end of production, however it will work on all years 1928-31. This harness has the flexible black loom instead of the steel conduit...
This handy bracket uses the lower starter mount bolt for mounting. Provides a perfect mount for the A-14300-D disconnect switch between the frame and the starter. Powder coated black. U.S.A.
This switch gets spliced in the cable going from the battery to the starter switch. If you ever would run into an electrical problem, this will cut off all the power. Installation is very simple...
All the grommets you will need for the firewall. U.S.A. Note: The late 31 grommet set is for A's with the indented firewall for the gas valve.
Correct authentic style flag terminal used throughout the Model A wiring harness. Preformed tinned brass. U.S.A.
No need to change or modify the stock gauges or senders. Just install the electronic voltage reducer on the back of each gauge, and the gauges will continue to run on 6-volts, while the rest...
