To order multiple products on this page, enter the quantity for each product you would like to purchase, and then select "add to cart" to checkout.
Cast bronze bracket that top of landau iron mounts to. Fits 68-A and 68-B Cabriolets. USA
Screws to the bottom of center bow and serves as a pivot point. Fits 68A and 68B Cabriolets. Cast bronze. U.S.A.
These kits are for closed cars only. Kits include top decking, padding, tacks hid-em welt trim and instructions. All kits are supplied with short grain cobra top decking. You must purchase some...
Mounts at the front of the car to tie the header over the windshield to the wooden side rails. Only available in pairs. U.S.A.
The panel above the door that rolls from the top of the door up to rib rail. You will have to put the holes in for mounting the panel and the rain gutters.
Screws to the bottom of the folding door pillar and holds the dress plate seal in place. Unpolished stainless steel. Holes are drilled but not countersunk so they can be used on either the left...
Skinny piece of rubber that fits under the dress plate of the upper folding post on Cabriolets. U.S.A.
This tip was used on the rear of the drip rails on 28-31 Tudor Sedans.
Used on the front of the drip rail molding on the 28-9 Briggs Fordor only. SS nail included.
Used on the rear of the drip rails on 1928-31 Sport Coupes, and 28-9 Business Coupes. Nickel plated.
These tips were used on the left & right front roof drip rail molding. Used on 1928-29 Coupes, and Tudors. SS nail included.
Used on the front of the drip rails on 1928-29 Sport Coupe, and Business Coupe. Nickel plated.
Used on Coupes & Tudor Sedans. This panel slips over the face of the wood header above the windshield. The finish on the steel one normally needs some finishing touches because it is hand made.
Runs across the top of the door opening. The wooden side rails set in this metal. The front edge has a piece of metal bent downward to attach to the door hinge post. Coupe and Sport Coupe only. U.S.A.
Chrome bracket used on 68-A and 68-B Cabriolets. Fastens to wood header to attach top to body. U.S.A.
This is the end cap that covers up the end of the Hide'm welt ends Very nice repo made exact as original. U.S.A.
Used to finish off the hide'm welt. Nickel finish. comes with nail. U.S.A.
Special pin that acts as a hinge pin where the rear and center bows pivot at the belt rail. Fits 68A and 68B Cabriolets. U.S.A.
