To order multiple products on this page, enter the quantity for each product you would like to purchase, and then select "add to cart" to checkout.
All the hardware needed to mount the rear spare tire mount to the body. U.S.A.
Steel face plate that must be used with tire band. This covers the sidewall of the tire. Bare steel paint as desired.
The brackets for installing a spare tire in the front fender for the 1930-31.
For the 1928-29 Model A. Right or Left, both use the same brackets.
For the side mount spare tire, these wells are welded into the fender. Made of good heavy steel. Good step by step instructions with measurements for installing these wells is covered in the...
Thin jam nut that goes down over the spare mount stud to adjust the angle of the spare. U.S.A.
The 1930-31 side mount bracket was originally riveted to the frame rail. One set per side. 3-5/16 D. X 1" Lg. Round Head Rivets. U.S.A.
Fits in the splash shield to fill the hole between the spare tire arm and the shield. U.S.A.
Bolts, castle nuts needed to mount the 1928-29 spare tire bracket to the frame. U.S.A.
These are the special bolts and plug for blocking off the holes in the rear of body where a spare was mounted. U.S.A.
This special bolt has a square shoulder on it. It is used on the side mount spare tire plates, and on the rear mount spare tire carriers that have a square hole in them. U.S.A.
Rear spare tire carrier in cast aluminum. U.S.A.
We have a big selection of these naugahyde tire covers. These covers are easy to clean and have the Ford logo silk screened on. They have a draw string on the back side to give them a nice...
This is the 3/8 x 24 D-nut that goes in the rear cross member that the carrier bolts to. U.S.A.
If you have the spare tire arm and all you are lacking is the plate, we offer just the plate.
Used on the rear mount spare tire carriers where there is a blind hole, or where there is not a square to accept the A-1448 bolt. U.S.A.
For the Coupes and Roadsters with a rear mounted spare tire. This bracket follows the contour of the curved inner panel, and the top bolt on the carrier goes through the hole in the end. Only...
Goes behind the panel below the deck lid and gives support for bolting the rear mount spare tire on to the body. Trunk applications. Can be shortened to work on 28-29's. U.S.A.
A popular accessory from back in the A' days. No additional mounting hardware is needed. Just snap around the tire, and it holds itself to the tire. Available in polished or unpolished stainless...