- 1928-29 Pickup Seat Clips
Backrest retainer clip set. Mounts to second hole in from each side where upper & lower cab back panels are bolted together.note: 1 set is pictured, 2 sets required.
- 1930-31 Pickup Seat Clips
Holds the backrest spring in position. Several different styles have been found. The upper clip in the top pictured set mounts to the face of the belt rail wood. The bottom pictured set had the...
- 28-9 Closed Cab Lower Panel
The complete lower panel for the back of the 28-9 Closed Cab Truck. Very nice repo. U.S.A.
- 28-9 Closed Cab Upper Panel
The complete upper panel for the back of the 28-9 Closed Cab Truck. Very nice repo. U.S.A.
- Bed Panel
This panel bolts to the frame between cab and bed. Lip sticks up between bed rails to keep cargo clean. U.S.A.
- Belt Rail Bolts
These large headed carriage
style bolts held the piece of
wood in the back of the cab
about in the middle. The heads
show on the outside. U.S.A.
- Brace & Corner Bracket Assembly
Fits in the upper back corner of the 28-9 Closed Cab Truck. U.S.A.
- Cab Brackets
For the Roadster Pick-up, these are the brackets that go in the very back corner. They tie the sub-rail, the rear quarter panel, and the cab back panel together. U.S.A.
- Cab Corners Extended
Rear cab corner panels for the 1928-29 closed cab truck. These corners are six inches longer than stock cab corners to lengthen the cab and give you more legroom.
- Closed Cab Dash Rail
Steel dash rail that fits coupes, tudor sedans, closed cab pickup, sedan delivery, deluxe delivery, taxi and station wagons. not as detailed as originals, use original if possible.
- Closed Cab Truck Doors
These doors 1928-29 closed cab trucks and 1926-27 coupe and tudor sedans. Door only, hinges, latches, garnish etc are not included.
- Complete Cab Corners
A pair of complete cab corners
for the 28-9 Closed Cab Trucks.
Exact in every datail.
- Corner Brace
Used on the 30-1 Closed Cab Truck back window. One was used on each corner of the window frame for attaching the frame to the back of the cab. U.S.A.
- Cowl Post
The long post that mounts just in front of the door and runs from the bottom of the cab to the roof. Fits 1928-29 closed cab truck.
- Cross Channels
For the 28-9 Rdst.
Pick-up, these rails,
run cross-ways between the sub-rails, and the floor pan and floorboards set down in them.
- Dispatch Pockets
Mounts to the kick panel.
included. Used on 30-1
Closed Cab Truck. U.S.A.
- Door Bottom Patch
These are about 6" high, and come in pairs only. U.S.A.
- Door Bumper Holder
This stamped steel part holds the
door bumper in place on the 28-9
Closed Cab Trucks.
- Door Hinge, 28-9 Truck
Cast bronze door hinges for the 28-9 closed cab truck. Longest one supplied, you will have to cut down the length and drill/tap mounting holes. USA
- Door Lever Anti-Rattler
The molded rubber part that fits around the inside door opening lever and under the garnish molding. Closed cars only. Used on some of the Model A Trucks with the slide type door openers. U.S.A.