To order multiple products on this page, enter the quantity for each product you would like to purchase, and then select "add to cart" to checkout.
This hood was only used on the 28-9 4-door Sedans. It has a bead on the side of the top panel & a different cowl contour. U.S.A.
The back retainer for the hood.
When using a 32' style center hinge on your model A, you will need this special retainer for the rear hood retainer on the cowl. U.S.A.
Used for all of the 1928-29 model A?s except the 4-door Sedans. U.S.A.
The back retainer for the hood
All of the 1930-31 model A?s used this hood! U.S.A.
1/8" double beaded lacing. Available in bulk for other applications. Sold by the foot. Cut to order so it is non-returnable. Asphalt treated cotton that is brown in color. USA
Mounts on the frame with the rubber bumper pressing against the hood to prevent rattles. Powder coated black -w-bumper riveted in place. U.S.A.
A very good reproduction of the original stainless steel cowl band used on the 30-1?s. There was a cowl band used on the 28-9 4-door Sedans, but this will not work on it. 1930-31 only. ...
Most cars are missing these little clips. They slip under the screw that holds the top of the cowl panel to the firewall and slip under the cowl band to hold it in position. U.S.A.
For the 28-9?s we offer 2 different cowl lacing kits. The original style uses a wire to hold the lacing down over the gas tank, and the pieces on the cowl panels were riveted on with raven rivets....
This is the special hook that holds the top lacing on. The hook that the wire attaches to. U.S.A.
For all of the 30-1 model A?s. This kit is just like Henry used. Complete with clips, screws, and rivets. For 1930-31. U.S.A.
Set of three special pan headed bolts used when installing the 30-1 cowl lacing. It comes with the cowl lacing kit.
This hood was used on the early 28?s only. The louvers on the side had a slight taper to them. U.S.A.
When using a 32' style center hinge on your model A, you will need this special retainer for the radiator shell.
A Chrome finished retainer that clamps over cowl molding strip.
A set of 6 correctly shaped round rubber bumpers. One goes under each hood clip, and one on each side in the middle on the support clip. Kit comes with correct black japaned tubular rivets for attaching....
