To order multiple products on this page, enter the quantity for each product you would like to purchase, and then select "add to cart" to checkout.
All chrome latch repair kit for both
headlight rims. U.S.A.
A cad plated spring for the
headlight latch. U.S.A.
Wire clips that hold the lens into
the rim. One kit is enough to do
These brackets are used for
attaching the front license plate to
the headlamp bar. 1928-31 U.S.A.
An aluminum frame with blue lettering over a white background. U.S.A.
Blue & red imprint on a
Mount as an extra
plate on the right side
or on the headlight bar. U.S.A.
Mounts on bottom of steering column. The light wire harness slips inside this unit to turn lights off and on.
This kit will let you convert your regular headlights into quartz headlights. Simply enlarge the hole in the center of the reflector, and install this kit. Gives much better lighting for night...
This kit gives you everything in
the picture. It comes with
gaskets for both
easily in any model A headlight. Puts off light just...
Kit comes complete with
reflectors, bulbs, and
sockets. Kit gives you
quartz driving bulbs
and amber turn signal
bulbs. Reflectors come
ready to accept the two bulbs. 12-volt only.
These bulbs are also known as "UGLY
BULBS". They are a direct replacement
for the original bulbs except they put off
much more light.
This is the spring steel clip that is
snapped into the top of the
headlight bucket that holds
the rim on the top. U.S.A.
Thin rubber pads that fit between the headlight bar and the fender. Thin type without border as original. U.S.A.
Sealed beam adapter kit. Kit puts the entire sealed beam behind the original lens. Does both headlights. If you are running a generator, you will have to turn your adjustable brush all the way...
When putting sealed beam bulbs or the quartz adapter kit in Model A buckets, you will need these. These press in the old hole where the original socket stuck out to fasten the headlight conduit...
Special socket used to plug into the bulb when using sealed beam or quartz bulbs. Can't be used with sealed beam bulbs in 30-1 headlamps. These are made out of very high heat resistant plastic...
This kit is for installing amber
directional bulbs inside your
original headlamps. You
will have to drill a hole in
your reflectors to install this
kit. Available in 12-volt only.
This socket is held in place with the
shoulder between the headlight bucket,
and the base plate. It holds the headlight socket in place at the base of the light. U.S.A.
This is the small clip that sticks out the bottom of the bucket that the "T" bar hooks onto to hold the rim on. U.S.A.
Polished stainless bar that clips to
A-13047 to hold the rim in place. U.S.A.