To order multiple products on this page, enter the quantity for each product you would like to purchase, and then select "add to cart" to checkout.
The 3rd adjustable brush in the generator mounts on this plate. U.S.A.
This is a new and improved part! This pulley has a smaller diameter than any other pulley that has been on the market to date. Therefore, it turns the alternator faster which is a plus on a model A motor....
These are a must for running the quartz sealed beam headlights or if you just simply want a more reliable charging system. These alternators are rebuilt using new components and bench tested before being...
Insulated nut for attaching wires to amp meter.
The trim ring only for the amp meter. Chrome plated.
The original type amp meter used by Ford. The A's never used a script amp meter, but some people like the looks. Use the 30-30 if you are running an alternator or if you have your generator turned up....
U.S.A.
This piece was originally riveted to the generator end plate. U.S.A.
Flat washer that goes between the bearing and the felt washer. U.S.A.
This bushing slips over the stud that the brush holder pivots on. U.S.A.
The two 10-32 x 1/2" thick headed hex screws with lock washers that go through terminals on original cutouts. U.S.A.
If you have an original cut-out, these are the special fiber washers that go where the bolts go through the cap. U.S.A.
The clip that attaches to the side of the generator cut out and slips over the post coming out of the generator. If ordering a cut out, this clip will come with it already. U.S.A.
Two screws and lock washers to hold the cutout to the generator. U.S.A.
Make your old cut-out solid state by installing this diode. Can be installed in your old cut-out if it is bad. Complete with instructions. Positive ground only. U.S.A.
A bushing was used in the rear end plate of the generator from April of 30 until the end of production. U.S.A.
