Model A Closed Car Windshield Parts

This windshield frame gasket is special for the reproduction aluminum windshield frames. Does both sides and the bottom. USA

Slotted oval headed chrome screws that hold the upright windshield garnish moldings to the windshield post. Sold in a pack of 6.

Fit on the car just like the normal swing arms except these have definite notches so they won't slide! Unpolished stainless steel with a satin finish. USA

This set is used to hold the swing arms to the windshield frame. 1 kit does both sides. If your windshield brackets do not have the threaded insert, the female nut in this kit will replace it.

Goes from the top of the windshield to the top. Used only on the 1930-31 Station Wagon. Laminated Fiberglass. USA

Nickel plated nuts to hold the swing arms when you open the windshield on closed cars. Cabriolet is the same nut except it has chrome plating.

These chrome cup shaped washers have a hard rubber insert that sets in them for going against the swing arms to grip better. 1 set does both sides. U.S.A.

Used on the closed cars to hold the windshield out for fresh air conditioning or closed to seal out the snow.

An exact copy of the windshield bracket that was used on all of the windshield frames for the swing arms to attach to. Mounting rivets included. U.S.A.

This trim piece goes between the windshield posts and sets between the gas tank and the windshield. 30-1 Coupe, Tudor, Closed Cab Truck:

This trim piece goes between the windshield posts and sets between the gas tank and the windshield. Fiberglass. This one was used on the Slant Windshield Model A's in 1931.

The gasket for the bottom and sides of the closed car steel windshield frame. Put the bottom in first, but don't cut it. Wait till the next day to finish the job, as this lets the rubber shrink so the...

This special nut was swedged into the windshield frame bracket to hold the swing arms. U.S.A.

...

This rubber keeps rain from coming in over the top of the windshield. Goes between windshield hinge and body. U.S.A.

The piece that the windshield hinges on. 28-29 is pictured on left, and 30-1 on right. You will have to drill all holes and cut tapers on ends. Closed car only. U.S.A.

This kit is all of the screws etc. for mounting the windshield hinge to the header, and the special small screws for joining the top and bottom halves of the frame. U.S.A.