Model A Carburetor

The brass adjustment needle that is controlled by your choke rod. This is an important item to your car's performance. Make sure that your point is in good shape. U.S.A.

The adjustment needle went into this brass seat in the 28-9 Zenith carbs. The later carbs were machined in the carb casting and didn't use this one. U.S.A.

For Zenith carbs. U.S.A.

At last, an air filter for the air maze that requited no modifications. Just take the screen out of your old air maze, and this filter will fit right on. Give your A engine the clean air it deserves....

It's a good idea to put an Air Maze on your car. First as an air cleaner and second, in case of a backfire, it's a flame arrester. Fits Zenith, but will work on Tillotson if throat is enlarged on the...

Due to clearance issues with the exhaust, our new design swings the filter under the carburetor. Makes changing the filter a breeze and you can still run your engine pans! Gives the old carb nice clean...

Kit contains special copper gasket and machined bolts that allow you to twist the 'B' carb when mounting it to the 'A' intake so your choke rod lines up. USA

Similar to the Grose-Jet style valve. This unit replaces the old needle and seat. This jet uses two balls instead of a needle to shut off the gas flow. Available for the A & B Zenith. U.S.A.

Set of four small fine threaded screws that attach the choke and throttle butterflies to the shafts. U.S.A.

For the Zenith carb. U.S.A.

The cad plated long bolt that joins the bowl of the Zenith carb to the top of the carb. U.S.A.

U.S.A.

A brass float for the tillotson carb.

A copy of the KR Wilson tool used in rebuilding the Zenith carbs. U.S.A.

The two bolts and lock wahsers used to bolt the carb to the intake. U.S.A.

Kit contains adapter bolt, lock washer, copper gasket, and fuel line fittings to adapt the 1932-34 4-cylinder carburetor to a model A. USA

An excellent movie that deals strictly with the Zenith carb. Covers the 17 different model A carbs. Shows: How to rebuild the swap meet carb! How to size jets & flow-test them. How to set the float...

Special threaded nut that holds the choke arm onto the choke shaft. This nut is thicker than the normal nut. U.S.A.