Model A Ford Carb Controls

Choke rod with chrome plated knob. Comes complete with sleeve and spring.

This sleeve on the choke rod holds the rod on at carburetor.

U.S.A.

Goes over choke rod on engine side of firewall. The A-9709 spring will hold it against the firewall. U.S.A.

...

This slips into the little bracket under the gas tank inside the car. The choke rod goes through this grommet. A little bit of dish soap will make it slip in easier. U.S.A.

An exact copy of the original Fulton accessory pedal. Chrome pedal with rubber insert that matches the Fulton ton pedal covers. Use with present accelerator by bolting onto the floorboards.

This style of accelerator cap is made just like the original was. It is fully machined part and it is plated. U.S.A.

This little spring mounts onto the throttle assembly that is bolted to the bell housing to return the gas pedal to the idle position. The early style was used on throttle assemblies that had a removable...

Cadmium plated control rods with the spring loaded ends. Ours are a bit more expensive than others, but they are made correctly and seat on the ball properly. Set consists of 3 rods: Spark, Throttle,...

Cut about 1/4" out of your spark rod that runs from the steering column to the distributor and install this sleeve. Locks with two allen set screws. Allows you to set the extremes of your spark adjustment....

This rubber pad fits both the accelerator cap and the footrest post. U.S.A.

Cad plated with rubber insert as original. U.S.A.

A cast aluminum base with screw holes. U.S.A.

Three wood screws used to attach the footrest base to the floorboard. U.S.A.