Jump to contentJump to sub-navigation
Welcome to our new website, If you had an account on our old system you will need to re-register.

Serving Hobbyists for Over 50 Years

(330) 549-5313
View Cart (0 Items)

I have a 1929 Model A. I have removed my oil pan f

remove the 1/8" slotted pipe plug that is in the middle of the block between the valve cover and the oil pan. this is where the oil runs through the block and into the valve area. when you slip the oil pump back into place, temp. hold it in place by screwing a 3/8-24 bolt in place of the 1/8" pipe plug you just removed. be carefull not to overtighten it, you just need enough pressure to hold the pump in place until you get the pan back on. after you have installed the pan, remove the bolt and replace the pipe plug. there is only one way the oil pump can go in, just make sure the pump is all the way up against the block. you just have to keep twisting the shaft in the pump until you feel it drop into place when you push it up. to be sure the pump is working you can remove the pipe plug I discussed earlier in my letter and crank the motor over. if you see oil coming out that hold, you know the pump is working.
Now Accepting: accepted payments A Verisign Secured Site: Verisign Secured
Copyright ©2016 Snyders Antique Auto Dan Snyders Antique Auto 12925 Woodworth Rd New Springfield, Ohio 44443 US Phone: (330) 549-5313