To order multiple products on this page, enter the quantity for each product you would like to purchase, and then select "add to cart" to checkout.
5/16" threaded rod goes through the floor bracket and hinge channel. It is removed to change seat adjustment on early Victoria & Deluxe Phaeton. U.S.A.
This armrest was used on
the sides of the back seat
of 4-door Sedans, and
Victorias. One kit does
Used on coupes and straight windshield 4-dr. sedans. These clips attach to the inside edge of the outer board that the seat tracks are attached to. These hit against the back side of the front...
Attaches to the lower area of the bolt flange where the rear body section attaches to the quarter panels. The side of the bracket with the single hole aims forward. The lower clips attached to...
Used with the A-63534-AR seat adjuster bolt. It is the rear bracket under the seat frame that the long rod sets in that adjusts the seat. It attaches to the bottom of the wood seat frame bracket....
Supports the front edge of the Tudor Sedan front seats. They have a 2" offset in them to give you more legroom. U.S.A.
This bolts to the back of the back seat backrest to attach it to the back of the car on all Victorias, A-400, and Deluxe Phaeton. U.S.A.
This style of handle was
used on the 30-1 Victoria, and the
Slant Windshield 4-drs. Chrome.
The saw-toothed style
seat adjuster with the
bracket that mounts to the front of the seat unit. Does not come with bracket that mounts to floor. Used on Dlx 2-Dr Sedans, Dlx Coupes, Vicky,...
The special threaded bolt that adjusts the screw type adjustable seat. The seat adjusting knob fits on the end of this. Used on 30-31 cars. U.S.A.
This style was used on 1929-31 Murray 4-doors to adjust the front seat. Used on 155-A/C, and 165-A/C. 19-1/16" long. U.S.A.
This bracket bolts to the front underside of the seat carriage wood (AWD-1510). The front edge hangs down and is what the head of the seat adjuster bolt is held in place with. Used on several...
This bracket bolts to the sill in front of the seat riser with the vertical portion (part with A-47832-N captivated in) coming up on the back side of the seat risers front edge. This bracket...
Used on the A-400's and Victoria's with adjustable driver's seat. Runs front to back under the driver's side seat to protect the seat adjuster and spring. Nails to the bottom of the seat wood.
This kit replaces the front
seat legs on the Tudor
Sedan seats and makes
the seat adjustable. Adjusts
forward and backward as well as up and down. One kit does one seat. U.S.A.
Special round nut that is caged in
the metal bracket on the seat
assembly. Used only on the
threaded style seat adj. unit. U.S.A.
This spring is about 6" long and is used on the seat adjuster of cars with the saw tooth style adjuster. U.S.A.
Used on the screw style seat
adjuster. Slides down on head of
seat add. bolt before going through bracket at the front of the seat. The original was brass, but this is a nylon for smoother...
2 are needed per car. This clip screws to the backrest wood and is what the seat back hangs on. Used on 1928-29 Coupes. U.S.A.